Page 1 of 1
Error when launching config
Posted: Sat Feb 08, 2020 12:33 am
by Rob49152
Whenever I try to launch the configure screen saver I get the error message
'Unable to execute gPhotoShow.scr /c, error 2'
I've uninstalled and re-installed a few times. I can configure only once after an install. I try again and I get the error.
Re: Error when launching config
Posted: Mon Feb 10, 2020 3:20 pm
by gpb
Hello,
Error 2 means file doesn't not exist. How do you configure screen saver ?
If you installed the 64 bit version of gPhotoShow executable name is different, to configure screen saver you should use the shortcut created by the installer or better Windows Settings / Control Panel
Re: Error when launching config
Posted: Sat Mar 21, 2020 12:43 am
by Rob49152
I get this error when I launch from the tray in the task bar.
I found that if I bring up the windows screen saver control panel and select configure it launches without any issue.
Re: Error when launching config
Posted: Sun Mar 22, 2020 5:03 pm
by gpb
Ok, now I understand. You are using ControlSS, right click on its icon, choose "gPhotoShow settings"->Configure
Untick the option "Start gphotoshow.scr directly..."
Close wth OK
now it will work