gPhotoShow Products Support Forum

Occasionally a notification appears identifying a corrupt file encountered. Is there a way this tool can identify all problem images before assigning/starting the saver?

Unfortunately, this isn't possible. The only way would be to open each file at startup, but that would take a long time.
Sometimes, the file itself isn't even corrupt; it could be an unsupported format or the wrong extension.

Is there a log file that reports these corrupt images that I can open and scan? - If not, consider adding this function. -thank you

There is the error log that contains all kind of errors and the extended log that contain additional info.

gpb wrote: Wed Aug 26, 2026 10:56 pm There is the error log that contains all kind of errors and the extended log that contain additional info.

do they contain the requested information? if so, what are the file names and where are they located?

MourningStar wrote: Thu Aug 27, 2026 1:13 am do they contain the requested information? if so, what are the file names and where are they located?

open the error log and you will see what it contains. If not enough enable extended logging. It contains much more info.

what are the file names and where are they located?

I found them