gPhotoShow Products Support Forum

I just switched to the DX version. Fewer 2D transitions but the monitor On/Off now works as it should.

Thank you so much for your help! I could not have done it without you.

To follow up on this... I turned on detailed logging and generated the attached file. You can see where I sent the Monitor Off via UDP about half way down the file. Then I send a Monitor On. The monitor does turn on but the Windows Desktop is displayed. In the Error Log, you can see that the Monitor ...

I am surprised by this answer. It was working until recently and I have been using Windows 11 for a long time. I think I am running it as SlideShow Maker. I followed the instructions on your website for setting up a Photo Frame and it runs gPhotoShow immediately after Windows is booted.

Also, I ...

I upgraded and installed V10.0.3 a few days ago running on Windows 11 current version. I've found that every time the monitor is turned off and then on again, gPhotoShow has been stopped - it just shows the Windows desktop. There are two ways the monitor off/on sequence can be done, but the result ...

Thank you! I see them now.

I've configured the "E" key and a MQTT button to exclude files (i.e. "add current file to the exclusion list)." When I press these, I do see the on-screen message that the file has been added to the exclusion list. But I can't find the exclusion list. Where is it? I looked in the Global Exclusion ...

Thank you so much for your response and good news!

Is there a way to enable/disable the Weather Info plugin through MQTT?

Apparently, kwd_filter and kwd_exclude both use the "Contain (use *?)" setting. Is there a way through MQTT to set either of them to "Do not contain (use *?)"? The main reason I'm asking this is because using "Contain" on the ...

Oops! Sorry I missed the help file. Kind of a rookie mistake.

Thanks for your help!

I'm in the process of implementing a digital pictureframe following your wonderful instructions. This page (https://www.gphotoshow.com/digital-picture-frame-diy-5.html) briefly describes some of the commands that are available but it is a little sketchy and I assume incomplete. Is there a more ...