Whenever I try to launch the configure screen saver I get the error message
'Unable to execute gPhotoShow.scr /c, error 2'
I've uninstalled and re-installed a few times. I can configure only once after an install. I try again and I get the error.
Error when launching config
Re: Error when launching config
Hello,
Error 2 means file doesn't not exist. How do you configure screen saver ?
If you installed the 64 bit version of gPhotoShow executable name is different, to configure screen saver you should use the shortcut created by the installer or better Windows Settings / Control Panel
Error 2 means file doesn't not exist. How do you configure screen saver ?
If you installed the 64 bit version of gPhotoShow executable name is different, to configure screen saver you should use the shortcut created by the installer or better Windows Settings / Control Panel
Gianpaolo Bottin
gPhotoShow.com
gPhotoShow.com
Re: Error when launching config
I get this error when I launch from the tray in the task bar.
I found that if I bring up the windows screen saver control panel and select configure it launches without any issue.
I found that if I bring up the windows screen saver control panel and select configure it launches without any issue.
Re: Error when launching config
Ok, now I understand. You are using ControlSS, right click on its icon, choose "gPhotoShow settings"->Configure
Untick the option "Start gphotoshow.scr directly..."
Close wth OK
now it will work
Untick the option "Start gphotoshow.scr directly..."
Close wth OK
now it will work
Gianpaolo Bottin
gPhotoShow.com
gPhotoShow.com